HVAC replacement, Louisville
Full HVAC system replacement in Louisville
Engineered replacement of complete heating and cooling systems for Louisville large homes, estates and commercial buildings.
- Insured
- EPA-certified technicians
- Design-build and plan-and-spec
- 24/7 emergency response
Full replacement in Louisville starts with what is already on the property. Historic mining-era homes in Old Town, 1970s through 1990s subdivisions, and newly rebuilt homes following the December 2021 Marshall Fire. We survey every system, then replace them together so capacity, zoning and controls finally work as one.
Louisville systems at replacement time
In Old Town Louisville's historic homes, furnace work often means working around tight basements and older venting. Rebuilt homes are going up to current energy codes, which makes heat pumps, radiant floors and balanced ventilation common design choices.
Replacement decisions in Louisville are easier with real numbers. We document equipment age and condition, run loads, and price repair, phased replacement and full replacement side by side.
Louisville project spec sheet
| Properties | Large homes, estates, multi-system residences, commercial buildings |
|---|---|
| Options | High-efficiency gas, dual-fuel, cold-climate heat pump, hydronic |
| Typical pricing | Whole-home luxury replacement $25,000 to $80,000+, typical range, exact pricing after plan review or site walk |
| County | Boulder County |
| Elevation | About 5,350 feet |
| Key areas | The Colorado Technology Center, Redtail Ridge, the McCaslin Boulevard corridor and downtown Main Street |
What a Louisville replacement includes
We document every unit, duct run and comfort complaint, run loads and measure static pressure, then present options from high-efficiency gas to dual-fuel and all-electric with tradeoffs explained.
- Equipment and duct survey
- Load calculation and static pressure
- Zoning and controls redesign
- Removal and disposal of old equipment
- Gas, venting and condensate
- Electrical coordination
- Permits and inspections
- Startup and balancing
Process
- Survey. Existing conditions or construction documents reviewed in detail
- Price. Scope, options and exclusions in writing, so the number holds
- Install. Scheduled work windows, protected finishes and clean sites
- Commission. Startup, balancing, controls and training before turnover
What we plan for in Louisville
- Old Town homes have tight lots and older layouts.
- Rebuilt homes go up under current energy codes, which makes heat pumps and ventilation design especially relevant.
- Homes that survived near the fire area may still have smoke residue concerns in ductwork.
Louisville sits at about 5,350 feet. At that elevation gas equipment needs the manufacturer's high-altitude setup and cooling capacity is lower than sea-level ratings suggest, so we select and set up equipment for the actual site.
We also deliver full HVAC system replacement in nearby Superior, Boulder, Broomfield and Erie. For the full overview, including our pricing approach, process and common questions, see HVAC system replacement in Denver.
Start a full HVAC system replacement project in Louisville
Send drawings, a scope or a site address in Louisville. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.
Louisville full HVAC system replacement questions
Do you replace commercial systems?
Yes, including rooftop units, split systems, boilers and VRF in office, retail, medical and light commercial buildings, after hours where needed.
Do you replace systems in Old Town Louisville and the Coal Creek area?
Yes. We replace complete systems across Louisville, including Old Town Louisville, the Coal Creek area, neighborhoods near Harper Lake and homes rebuilt after the Marshall Fire.
Do you fix ductwork during replacement?
Yes. We measure static pressure and review returns, and duct corrections are part of the redesign when the numbers call for them.
How much does full replacement cost in Louisville?
For large homes, a typical range is $25,000 to $80,000 or more depending on systems, zoning and ductwork. Exact pricing after plan review or site walk.
Do you handle permits?
Yes. We pull permits where required, schedule inspections and register equipment warranties at completion.