Services Commercial Residential Service agreements About Contact Service areas Request a bid Call (303) 720-3954

Custom home HVAC, Northglenn

Custom home HVAC in Northglenn

Mechanical design and installation for luxury new builds and major remodels in Northglenn, coordinated with your builder and architect.

  • Insured
  • EPA-certified technicians
  • Design-build and plan-and-spec
  • 24/7 emergency response

Northglenn began as a planned suburb north of Denver in the late 1950s and 1960s, and most of its housing dates from that first wave of building. Larger homes are fewer here, but full remodels increasingly replace original equipment with zoned modern systems. Our job is a home that stays quiet and even in every room, with equipment that can be serviced for decades.

Northglenn project spec sheet

Custom home HVAC in Northglenn
HeatingModulating furnaces, heat pumps, condensing boilers, radiant floors
ComfortHumidification, fresh air, high-MERV filtration, zoning
PricingPer plans after review
CountyAdams County
ElevationAbout 5,450 feet
Key areasNorthglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street

What Northglenn custom homes ask for

We work in neighborhoods around Webster Lake, homes near E.B. Rains Jr. Memorial Park and the 104th Avenue corridor. Largely 1960s and 1970s homes from the city's origin as a planned community, with newer infill and redevelopment along its main corridors.

Northglenn began as a planned suburb north of Denver in the late 1950s and 1960s, and most of its housing dates from that first wave of building. Large glass, vaulted great rooms, walkout lower levels and guest wings all carry different loads, so a custom home here needs zoning designed from the plans, not copied from a production house.

Our custom home scope in Northglenn

We calculate heat loss and gain room by room, propose zoning and equipment locations, and review routes with the architect before framing. Radiant, snowmelt, humidification and ventilation are designed as one system.

  • Startup, balancing and owner training
  • Quiet equipment placement
  • Room-by-room load calculation
  • Zoning plan by level, wing and exposure
  • Hydronic radiant floors
  • Snowmelt for drives and terraces
  • Whole-home humidification
  • ERV or HRV fresh air

Process

  1. Walk or review. A site walk or plan review to understand the building, access and goals
  2. Proposal. A written scope with equipment, schedule, exclusions and price
  3. Build. Installation coordinated with your team, the other trades and the building
  4. Close out. Startup, documentation and a walkthrough with the owner or manager

Local conditions in Northglenn

  • Homes from the 1960s and 1970s are often on their third or fourth furnace, with original ductwork that was never resized.
  • Retail and office buildings along I-25 and the main corridors run on aging rooftop units.
  • Remodels and additions have often expanded homes without updating the HVAC design.

Altitude is a design input here. At about 5,450 feet, thinner air reduces combustion and air-side capacity, and we correct equipment selection and gas setup for it on every Northglenn project.

We also deliver custom home HVAC in nearby Thornton, Westminster, Commerce City and Broomfield. For the full overview, including our pricing approach, process and common questions, see custom home HVAC in Denver.

Start a custom home HVAC project in Northglenn

Send drawings, a scope or a site address in Northglenn. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.

Northglenn custom home HVAC questions

Do you build custom homes in neighborhoods around Webster Lake?

Yes. We work on custom homes across Northglenn, including neighborhoods around Webster Lake, homes near E.B. Rains Jr. Memorial Park, the 104th Avenue corridor and neighborhoods along Washington Street.

Does Northglenn's elevation change the design?

Yes. At about 5,450 feet, gas equipment needs high-altitude setup and cooling capacity drops, so equipment is selected with altitude correction.

Can you integrate with home automation?

Yes. We specify thermostats and controls that work with common home automation platforms and coordinate the integration with your integrator.

Is geothermal an option?

It can be. We plan geothermal-ready layouts and coordinate with drilling contractors when an owner chooses ground-source heat pumps.

Do you work directly with owners?

Yes. Many owners bring us in alongside their builder so mechanical decisions about comfort, noise and controls are made with full information.