Rooftop unit replacement, Northglenn
Rooftop unit replacement in Northglenn
From one unit to a full roof, RTU replacement in Northglenn planned before the crane arrives.
- Insured
- EPA-certified technicians
- Design-build and plan-and-spec
- 24/7 emergency response
Northglenn began as a planned suburb north of Denver in the late 1950s and 1960s, and most of its housing dates from that first wave of building. Northglenn's commercial property is concentrated in retail centers and offices along I-25, 104th Avenue and 120th Avenue, much of it on aging packaged rooftop units. Rooftop unit replacement is one of the most common projects we run for owners and property managers here.
Rooftop work in Northglenn
Redevelopment along the main corridors and infill multifamily are the main sources of new construction in this largely built-out city. RTU work clusters around Northglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street.
Owners and managers in Northglenn usually replace RTUs for one of three reasons: a failed compressor or heat exchanger, rising repair bills, or a tenant change. We plan each changeout so the building reopens on schedule.
Northglenn project spec sheet
| County | Adams County |
|---|---|
| Elevation | About 5,450 feet |
| Key areas | Northglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street |
| Configurations | Gas/electric, heat pump, electric heat, economizer, VAV |
| Lift | Crane, rigging plan, street use where required |
| Typical pricing | $15,000 to $60,000+ per unit, typical range, exact pricing after plan review or site walk |
What a Northglenn RTU changeout includes
After the set, we complete connections, economizer and controls setup, and a full startup on heating and cooling, then document each unit for the owner.
- Replacement equipment selection
- Structural and roofer coordination
- Crane and rigging plan
- Curb adapters or new curbs
- Gas, electrical and condensate
- Economizer and controls
- Startup reports
- Disposal of old units
Process
- Walk or review. A site walk or plan review to understand the building, access and goals
- Proposal. A written scope with equipment, schedule, exclusions and price
- Build. Installation coordinated with your team, the other trades and the building
- Close out. Startup, documentation and a walkthrough with the owner or manager
Site factors in Northglenn
- Retail and office buildings along I-25 and the main corridors run on aging rooftop units.
- Remodels and additions have often expanded homes without updating the HVAC design.
- Homes from the 1960s and 1970s are often on their third or fourth furnace, with original ductwork that was never resized.
Northglenn sits at about 5,450 feet. At that elevation gas equipment needs the manufacturer's high-altitude setup and cooling capacity is lower than sea-level ratings suggest, so we select and set up equipment for the actual site.
We also deliver rooftop unit replacement in nearby Thornton, Westminster, Commerce City and Broomfield. For the full overview, including our pricing approach, process and common questions, see rooftop unit replacement in Denver.
Start a rooftop unit replacement project in Northglenn
Send drawings, a scope or a site address in Northglenn. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.
Northglenn rooftop unit replacement questions
Do you replace RTUs around Northglenn Marketplace?
Yes. We replace rooftop units across Northglenn, including Northglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street.
Can Northglenn changeouts happen after hours?
Yes. Most Northglenn changeouts are scheduled early mornings, weekends or after hours.
How many units in one day?
Often several, depending on unit size, access and crane reach. Grouping units into one crane day lowers the lift cost per unit.
Do you maintain RTUs afterward?
Yes. Planned maintenance agreements cover filters, belts, coils, economizers and safeties, with a written report after each visit.
Do hail guards make sense?
On exposed Front Range roofs they are worth considering. Hail can flatten condenser coil fins in a single storm and cut capacity.