New construction HVAC, Northglenn
HVAC for new buildings in Northglenn
Mechanical scope for ground-up projects in Northglenn, from load calculations and submittals to startup and closeout.
- Insured
- EPA-certified technicians
- Design-build and plan-and-spec
- 24/7 emergency response
Northglenn began as a planned suburb north of Denver in the late 1950s and 1960s, and most of its housing dates from that first wave of building. Redevelopment along the main corridors and infill multifamily are the main sources of new construction in this largely built-out city. When a new building goes up here, we can price the HVAC from plans or design it with your team from schematic design forward.
The Northglenn development picture
Northglenn's commercial property is concentrated in retail centers and offices along I-25, 104th Avenue and 120th Avenue, much of it on aging packaged rooftop units. Active areas include Northglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street.
Every new building in Northglenn has to pass inspection, satisfy current energy codes and work for its owner for decades. Larger homes are fewer here, but full remodels increasingly replace original equipment with zoned modern systems. We size systems from loads, not rules of thumb, and coordinate early with the framer, plumber and electrician.
Northglenn project spec sheet
| Project types | Commercial, mixed-use, multifamily, townhomes, custom homes |
|---|---|
| Delivery | Design-build, design-assist, plan-and-spec |
| Systems | RTUs, split systems, VRF, heat pumps, boilers, ERV and DOAS |
| County | Adams County |
| Elevation | About 5,450 feet |
| Key areas | Northglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street |
What we deliver on Northglenn new builds
Send drawings, specification and schedule. We return a written bid with clarifications and exclusions, then handle submittals, rough-in, inspections, trim and startup in step with the other trades.
- Sleeves and rough-in
- Gas piping and venting coordination
- Ventilation and exhaust
- Rough and final inspections
- Startup and balancing coordination
- Closeout documents and training
- Multifamily typical unit details
- Load calculations and system selection
Process
- Survey. Existing conditions or construction documents reviewed in detail
- Price. Scope, options and exclusions in writing, so the number holds
- Install. Scheduled work windows, protected finishes and clean sites
- Commission. Startup, balancing, controls and training before turnover
What we plan for in Northglenn
- Homes from the 1960s and 1970s are often on their third or fourth furnace, with original ductwork that was never resized.
- Retail and office buildings along I-25 and the main corridors run on aging rooftop units.
- Remodels and additions have often expanded homes without updating the HVAC design.
At about 5,450 feet, Northglenn equipment works in thin air, intense sun and hail. We select capacity with altitude correction, set gas equipment to the manufacturer's elevation guidance and plan outdoor equipment for hail exposure.
We also deliver new construction HVAC in nearby Thornton, Westminster, Commerce City and Broomfield. For the full overview, including our pricing approach, process and common questions, see new construction HVAC in Denver.
Start a new construction HVAC project in Northglenn
Send drawings, a scope or a site address in Northglenn. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.
Northglenn new construction HVAC questions
Can you do design-build mechanical?
Yes. We run loads, select systems and lay out ductwork and equipment, coordinating with a mechanical engineer of record wherever stamped drawings are required.
Do you build around Northglenn Marketplace and the I-25 corridor?
Yes. We price and build mechanical packages across Northglenn, including Northglenn Marketplace, the I-25 corridor, the 104th Avenue and 120th Avenue corridors and Washington Street.
When should we bring you in?
At schematic design for design-build, so equipment space and duct routes are protected, or at bid time for plan-and-spec work.
Do you price Northglenn projects from plans?
Yes. Send drawings, specification and schedule for your Northglenn project and we return a written bid with scope, clarifications and exclusions.
Do you build multifamily?
Yes. We set typical unit details with the GC early, then hold them consistently from rough-in to trim so inspections stay predictable on every floor.