HVAC replacement, Aurora
Full HVAC system replacement in Aurora
Engineered replacement of complete heating and cooling systems for Aurora large homes, estates and commercial buildings.
- Insured
- EPA-certified technicians
- Design-build and plan-and-spec
- 24/7 emergency response
Aurora is the metro's largest suburb and spans three counties, so housing age and equipment vary widely from one zip code to the next. Everything from 1950s and 1960s homes in north Aurora to large newer homes in southeast Aurora's golf and master-planned communities. When the original equipment reaches the end, we plan a full replacement rather than swapping one box at a time.
Replacement conditions in Aurora
The right furnace answer in a 1960s north Aurora ranch is very different from a 2000s home in Saddle Rock, and we recommend and price accordingly. Southeast Aurora communities like Blackstone and Saddle Rock include large homes where zoning and full-system replacement are common projects.
Aurora is the metro's largest suburb and spans three counties, so housing age and equipment vary widely from one zip code to the next. Many properties here carry systems installed at different times by different contractors, and a full replacement is the chance to bring capacity, ductwork, zoning and controls back into one coherent design.
Aurora project spec sheet
| County | Arapahoe, Adams and Douglas Counties |
|---|---|
| Elevation | About 5,400 to 5,500 feet |
| Key areas | The Anschutz Medical Campus and Fitzsimons area, Southlands, the Gaylord Rockies and E-470 corridor and the Aurora Town Center area |
| Properties | Large homes, estates, multi-system residences, commercial buildings |
| Options | High-efficiency gas, dual-fuel, cold-climate heat pump, hydronic |
| Typical pricing | Whole-home luxury replacement $25,000 to $80,000+, typical range, exact pricing after plan review or site walk |
What a Aurora replacement includes
Where several systems serve one home, we balance capacity across them, standardize equipment, add zoning where it belongs and set up one control strategy.
- Warranty registration
- Phased scheduling
- Equipment and duct survey
- Load calculation and static pressure
- Zoning and controls redesign
- Removal and disposal of old equipment
- Gas, venting and condensate
- Electrical coordination
Process
- Walk or review. A site walk or plan review to understand the building, access and goals
- Proposal. A written scope with equipment, schedule, exclusions and price
- Build. Installation coordinated with your team, the other trades and the building
- Close out. Startup, documentation and a walkthrough with the owner or manager
What we plan for in Aurora
- Open eastern plains exposure means wind and hail on outdoor units.
- Older north Aurora homes may still have original ductwork and furnaces at the end of their life.
- Southeast communities like Blackstone and Saddle Rock have larger homes that benefit from zoning and high-efficiency equipment.
Altitude is a design input here. At about 5,400 to 5,500 feet, thinner air reduces combustion and air-side capacity, and we correct equipment selection and gas setup for it on every Aurora project.
We also deliver full HVAC system replacement in nearby Commerce City, Centennial, Parker and Cherry Creek. For the full overview, including our pricing approach, process and common questions, see HVAC system replacement in Denver.
Start a full HVAC system replacement project in Aurora
Send drawings, a scope or a site address in Aurora. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.
Aurora full HVAC system replacement questions
Do you replace systems in Southlands and Saddle Rock?
Yes. We replace complete systems across Aurora, including Southlands, Saddle Rock, Tallyn's Reach, Blackstone and older neighborhoods in north Aurora.
How much does full replacement cost in Aurora?
For large homes, a typical range is $25,000 to $80,000 or more depending on systems, zoning and ductwork. Exact pricing after plan review or site walk.
Will we be without heat?
No. We phase the work system by system so the home or building keeps heat or cooling throughout the project.
Should we consider heat pumps?
It is worth comparing. We price cold-climate heat pumps and dual-fuel systems side by side with high-efficiency gas, with operating tradeoffs explained.
Do you replace commercial systems?
Yes, including rooftop units, split systems, boilers and VRF in office, retail, medical and light commercial buildings, after hours where needed.