New construction HVAC, Aurora
Aurora new construction mechanical
Bid-ready HVAC pricing for Aurora general contractors, developers and custom home builders.
- Insured
- EPA-certified technicians
- Design-build and plan-and-spec
- 24/7 emergency response
Aurora is the metro's largest suburb and spans three counties, so housing age and equipment vary widely from one zip code to the next. Aurora is one of the metro's largest new construction markets, with master-planned communities, multifamily and industrial projects along the E-470 corridor. When a new building goes up here, we can price the HVAC from plans or design it with your team from schematic design forward.
The Aurora development picture
Recent and ongoing activity centers on the Anschutz Medical Campus and Fitzsimons area, Southlands, the Gaylord Rockies and E-470 corridor and the Aurora Town Center area. Aurora spans hospital and research buildings at Anschutz, regional retail at Southlands and Aurora Town Center, and a large and growing base of warehouses, flex and hospitality along E-470.
Developers and builders in Aurora need mechanical pricing they can trust at bid time. Aurora spans hospital and research buildings at Anschutz, regional retail at Southlands and Aurora Town Center, and a large and growing base of warehouses, flex and hospitality along E-470. Clear scope, clarifications and exclusions keep the number honest from contract to closeout.
Aurora project spec sheet
| Project types | Commercial, mixed-use, multifamily, townhomes, custom homes |
|---|---|
| Delivery | Design-build, design-assist, plan-and-spec |
| Systems | RTUs, split systems, VRF, heat pumps, boilers, ERV and DOAS |
| County | Arapahoe, Adams and Douglas Counties |
| Elevation | About 5,400 to 5,500 feet |
| Key areas | The Anschutz Medical Campus and Fitzsimons area, Southlands, the Gaylord Rockies and E-470 corridor and the Aurora Town Center area |
How a Aurora new construction package runs
In design-build we run loads, select systems and lay out ductwork, coordinating with a mechanical engineer of record when stamped drawings are required. In plan-and-spec we price exactly what the documents show.
- Startup and balancing coordination
- Closeout documents and training
- Multifamily typical unit details
- Load calculations and system selection
- Duct design and equipment layout
- Submittals and RFIs
- Sleeves and rough-in
- Gas piping and venting coordination
Process
- Survey. Existing conditions or construction documents reviewed in detail
- Price. Scope, options and exclusions in writing, so the number holds
- Install. Scheduled work windows, protected finishes and clean sites
- Commission. Startup, balancing, controls and training before turnover
What we plan for in Aurora
- Southeast communities like Blackstone and Saddle Rock have larger homes that benefit from zoning and high-efficiency equipment.
- Open eastern plains exposure means wind and hail on outdoor units.
- Older north Aurora homes may still have original ductwork and furnaces at the end of their life.
Altitude is a design input here. At about 5,400 to 5,500 feet, thinner air reduces combustion and air-side capacity, and we correct equipment selection and gas setup for it on every Aurora project.
We also deliver new construction HVAC in nearby Commerce City, Centennial, Parker and Cherry Creek. For the full overview, including our pricing approach, process and common questions, see new construction HVAC in Denver.
Start a new construction HVAC project in Aurora
Send drawings, a scope or a site address in Aurora. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.
Aurora new construction HVAC questions
Do you build multifamily?
Yes. We set typical unit details with the GC early, then hold them consistently from rough-in to trim so inspections stay predictable on every floor.
Do you build around the Anschutz Medical Campus and Fitzsimons area and Southlands?
Yes. We price and build mechanical packages across Aurora, including the Anschutz Medical Campus and Fitzsimons area, Southlands, the Gaylord Rockies and E-470 corridor and the Aurora Town Center area.
Do you handle inspections?
Yes. We coordinate rough and final mechanical inspections and correct any items quickly so the schedule keeps moving.
Do you price Aurora projects from plans?
Yes. Send drawings, specification and schedule for your Aurora project and we return a written bid with scope, clarifications and exclusions.
Do you work with custom home builders?
Yes. We handle zoning, hydronic radiant, snowmelt, humidification, ventilation and controls for luxury custom homes, coordinated with the builder and architect.