New construction HVAC, Commerce City
New construction HVAC in Commerce City
Mechanical scope for ground-up projects in Commerce City, from load calculations and submittals to startup and closeout.
- Insured
- EPA-certified technicians
- Design-build and plan-and-spec
- 24/7 emergency response
New construction in Commerce City keeps moving. Reunion and the land along E-470 continue to add homes, multifamily and commercial pads, and industrial and distribution buildings keep going up along the interstate corridors. We bring loads, equipment selection, submittals and clean rough-in to every job, and we flag document conflicts early rather than at change order time.
New construction in Commerce City
We follow growth across the I-270 and I-76 industrial corridor, the Prairie Gateway area, the Highway 2 and Vasquez Boulevard corridor and Reunion and the E-470 corridor. Commerce City carries one of the metro's largest concentrations of industrial, warehouse, logistics and rail-served buildings along I-270 and I-76, plus new retail serving its growing neighborhoods.
Every new building in Commerce City has to pass inspection, satisfy current energy codes and work for its owner for decades. Larger new homes in Reunion and the northeast neighborhoods are the most common candidates for zoned, upgraded systems. We size systems from loads, not rules of thumb, and coordinate early with the framer, plumber and electrician.
Commerce City project spec sheet
| County | Adams County |
|---|---|
| Elevation | About 5,150 feet |
| Key areas | The I-270 and I-76 industrial corridor, the Prairie Gateway area, the Highway 2 and Vasquez Boulevard corridor and Reunion and the E-470 corridor |
| Project types | Commercial, mixed-use, multifamily, townhomes, custom homes |
| Delivery | Design-build, design-assist, plan-and-spec |
| Systems | RTUs, split systems, VRF, heat pumps, boilers, ERV and DOAS |
How a Commerce City new construction package runs
We build repeatable typical details for multifamily, protect equipment space early on custom homes, and deliver startup reports and closeout documents at turnover.
- Multifamily typical unit details
- Load calculations and system selection
- Duct design and equipment layout
- Submittals and RFIs
- Sleeves and rough-in
- Gas piping and venting coordination
- Ventilation and exhaust
- Rough and final inspections
Process
- Walk or review. A site walk or plan review to understand the building, access and goals
- Proposal. A written scope with equipment, schedule, exclusions and price
- Build. Installation coordinated with your team, the other trades and the building
- Close out. Startup, documentation and a walkthrough with the owner or manager
What we plan for in Commerce City
- Open plains exposure brings wind, dust and hail to outdoor and rooftop equipment.
- Industrial and warehouse buildings depend on rooftop units, unit heaters and make-up air that run hard through Front Range winters.
- Newer neighborhoods in Reunion and Belle Creek are reaching the age where builder-grade equipment needs its first major work.
Altitude is a design input here. At about 5,150 feet, thinner air reduces combustion and air-side capacity, and we correct equipment selection and gas setup for it on every Commerce City project.
We also deliver new construction HVAC in nearby Thornton, Brighton, Aurora and Northglenn. For the full overview, including our pricing approach, process and common questions, see new construction HVAC in Denver.
Start a new construction HVAC project in Commerce City
Send drawings, a scope or a site address in Commerce City. We reply with next steps, the information we need and a time for a plan review or site walk, and the scope is in writing before anything is scheduled.
Commerce City new construction HVAC questions
Do you build around the I-270 and I-76 industrial corridor and the Prairie Gateway area?
Yes. We price and build mechanical packages across Commerce City, including the I-270 and I-76 industrial corridor, the Prairie Gateway area, the Highway 2 and Vasquez Boulevard corridor and Reunion and the E-470 corridor.
Do you price Commerce City projects from plans?
Yes. Send drawings, specification and schedule for your Commerce City project and we return a written bid with scope, clarifications and exclusions.
Do you work with custom home builders?
Yes. We handle zoning, hydronic radiant, snowmelt, humidification, ventilation and controls for luxury custom homes, coordinated with the builder and architect.
What do we get at closeout?
Startup reports, equipment lists with model and serial numbers, warranty registrations, balancing coordination and owner or facility staff training.
Can you do design-build mechanical?
Yes. We run loads, select systems and lay out ductwork and equipment, coordinating with a mechanical engineer of record wherever stamped drawings are required.